Part / Drawing Request
✕
More info: Uni-Max® Pro product page
Troubleshooting
Articles
The Uni-Max® pump is cycling, but the output is inconsistent.
230 Micro Pump™ is not stroking.
No fluid coming out of 230 Micro Pump™.
Nozzle air flow restriction in Single Line Systems with high viscosity fluids.
Pulse R Fault Codes.
Solenoid valve stuck open or closed.
Low-level switch does not change state.
Pulse generator making a high-pitched noise and/or does not adjust.
There is fluid in the outer coax tubing.
Fluid is dripping from nozzles
Smoking tools
Too much mist/fog in the air.
more
Installation / Setup
Articles
How to install the Bat or BSB & BSG nozzles.
How to wire the Pulse R with flying leads and Air Solenoid together.
How to trim coaxial tubing.
How to rebuild my 230 Micro Pump™.
How to connect a nozzle to the Uni-Max® ST or Uni-Max® PRO.
How to set up and maintain the air trap.
How to wire my solenoid valve.
What should my initial system setting be?
Can I run lubricated air to the system?
How to prevent air metering screw from moving or backing out?
System Maintenance
General
Articles
What is the brass knob on my MQL system?
When do I use coiled versus straight tubing on a Single Line system?
How to adjust the 230 Micro Pump™ output.
How to prevent someone from turning the 230 Micro Pump™ adjustment knob.
What does the "P" mean on my 230 Micro™ Pump adjustment knob?
How to replace a 230 Micro Pump™.
What the numbers on a 230 Micro Pump™ mean?
How to change modes on a Pulse R.
Timing with multiple Pulse R's at the same rate.
Pulse R Display Units.
What fluids and components should be kept out of Unist systems?
What is the mesh screen size on a 16, 32, or 64 oz fluid reservoir?
What are my options for reservoirs larger than 64 oz?
Why is there a hole in the splicer pin?
Not finding what you need?