Part / Drawing Request
✕
More info: Uni-Max® ST product page
Troubleshooting
Articles
The Uni-Max® pump is cycling, but the output is inconsistent.
230 Micro Pump™ is not stroking.
No fluid coming out of 230 Micro Pump™.
Nozzle air flow restriction in Single Line Systems with high viscosity fluids.
Pulse R Fault Codes.
Solenoid valve stuck open or closed.
Low-level switch does not change state.
Pulse generator making a high-pitched noise and/or does not adjust.
There is fluid in the outer coax tubing.
Fluid is dripping from nozzles
Smoking tools
Too much mist/fog in the air.
more
Installation / Setup
Articles
How to install the Bat or BSB & BSG nozzles.
How to trim coaxial tubing.
How to rebuild my 230 Micro Pump™.
How to connect a nozzle to the Uni-Max® ST or Uni-Max® PRO.
How to prime the Uni-Max® ST.
How to set up and maintain the air trap.
How to wire my solenoid valve.
What should my initial system setting be?
Can I run lubricated air to the system?
How to prevent air metering screw from moving or backing out?
System Maintenance
General
Articles
When do I use coiled versus straight tubing on a Single Line system?
How to adjust the 230 Micro Pump™ output.
How to prevent someone from turning the 230 Micro Pump™ adjustment knob.
What does the "P" mean on my 230 Micro™ Pump adjustment knob?
How to replace a 230 Micro Pump™.
What the numbers on a 230 Micro Pump™ mean?
How to change modes on a Pulse R.
Pulse R Display Units.
What fluids and components should be kept out of Unist systems?
What is the mesh screen size on a 16, 32, or 64 oz fluid reservoir?
What are my options for reservoirs larger than 64 oz?
Why is there a hole in the splicer pin?
Not finding what you need?